Contents ▲ 183 ▼ Index
6 Select a Destination for the chip data file (.xad) that will be generated as the result of
the chip run. You can also specify a custom File Prefix for this file.
7 If required, change the Data Acquisition Parameters:
a Enter the number of samples you want to be measured.
When preparing the chip (see “Preparing Samples and Chips for Flow Cytometric
Assays” on page 185), keep in mind that you have to follow the sequence of the
sample wells. For example, if you want to measure 3 samples, you have to fill the
wells 1, 2, and 3 with your samples, and the remaining wells with cell buffer solution.
To Next Page
Loading...
Need help?
General
