Contents ▲ 241 ▼ Index
Displaying the Results of Regions
The measurement results and calculations for regions are displayed in the result table
below the dot plot. In predefined assays, only one region is available, while for generic
assays, dot plots can have as many regions as you like.
The following values are displayed:
Region The default region All Events is always displayed in the first row and
shows the values for all detected events. For each further region (see
“How to Add Regions to Dot Plots (Generic Assay only)” on
page 234), a row is added to the table.
XMean Mean fluorescence values in x direction.
YMean Mean fluorescence values in y direction.
#Events Number of events for each region added to the dot plot.
% Total Percentage of events for each region added to the dot plot.
% of gated Percentage of the gated events in the region.
StdDevX Standard deviation to the mean fluorescence value in x direction.
StdDevY Standard deviation to the mean fluorescence value in y direction.
CV%X Coefficient of variation of the x values.
CV%Y Coefficient of variation of the y values.
X GMean Geometric mean of the x values.
Y GMean Geometric mean of the y values.
To Next Page
Loading...
