Accessories and Options
Agilent 4100 Microwave Plasma Atomic Emission Spectrometer Site Preparation Guide 41
Environmental conditions
The SPS 3 accessory is suitable only for indoor use. The site should
be selected to avoid dusty or corrosive atmospheres.
NOTE
Extra maintenance may be required on the SPS 3 if it is operated in excessively
dusty or corrosive conditions.
An Agilent supplied trolley is available for the SPS 3 for purchase
(part number 9910056300). A drain vessel must also be
accommodated.
Multimode Sample Introduction System (MSIS)
(Part number G8000-63003)
The MSIS, Multimode Sample Introduction System, provides the
ability to nebulize liquid samples and create volatile hydrides for
introduction to the plasma in one sample introduction system. It uses
the highly efficient, thin-film hydride generation technology for
creating hydrides.
The MSIS can be used in any one of three modes, sample nebulization
only, hydride generation only and simultaneous nebulization and
hydride generation.
Use of this accessory requires installation of the 5-channel peristaltic
pump, P/N G8000-63002, and use of the inert OneNeb concentric
nebulizer, P/N 2010126900, both available from Agilent.
To Next Page
Loading...
Need help?
General
