Agilent Technologies 89410A - Page 75

HP-IB
about the HP-IB HT
addressable only HT
devices, setting up GS 6-2
HP-IB address: analyzer HT
HP-IB address: external devices HT
HP-IB address: external disk drive HT
HP-IB address: external receiver HT
HP-IB address: plotter HT
HP-IB address: printer HT
HP-IB connector GS 7-11
HP-IB controllers HT
keys that have HP-IB commands HT
LAN use OP 10-6
system controller HT
I
I-BASIC, instrument BASIC
See BASIC
I/Q information
See demodulation, digital
ideal state softkey HT
IF bandwidth, external receiver HT
IF center frequency, external
receiver HT
IF section (0-10 mhz) softkey HT
IF trigger
See trigger
pulse search OP 18-16
incoming inspection GS 7-5
indent softkey HT
indicators, display HT
INF, meaning of HT
information bandwidth OP 14-3,
OP 14-10
input channels HT
about input channels HT
channel 2 with rf section HT
clearing input overloads HT
compensating for gain & delay HT
connections HT
coupling: ac or dc HT
dBm calculations HT
disabling HT
disabling the anti-alias filter HT
input impedance HT
input-state table HT
input hardkey HT
input section (ch1 + j*ch2) softkey HT
input state GS 6-9
installation GS 7-7
installing options HT
instantaneous spectrum HT
instrument mode hardkey HT
interface
HP-IB GS 7-11
LAN GS 7-10
parallel GS 7-11
serial GS 7-10
IQ measured signal OP 17-9, OP 18-10
IQ reference signal OP 17-9, OP 18-10
Italian softkey HT
K
keyboard HT
about the keyboard HT
connecting GS 7-14
keyboard connector HT
keyboard type HT
knob HT
about the knob HT
changing the operation of HT
L
LAN GS 7-10
about advanced LAN (option UG7) HT
about the lan HT
activating OP 10-5
addressing OP 10-4
and FTP OP 10-10
connectors, descriptions HT
controlling the analyzer via the lan HT
ethernet address, displaying HT
FTP (File Transfer Protocol), using HT
gateway address, setting HT
HP-IB with OP 10-6
interface, connecting OP 10-1
IP address, setting HT
port, configuring HT
ports, activating HT
ports, selecting HT
subnet mask, setting HT
Telnet, about HT
X-Windows with OP 10-7
X11 display, configuring HT
X11 display, control HT
X11 display, setting the update rate HT
X11 IP address, setting HT
LAN (local area network) HT
leakage OP 14-6
learning products (manuals) HT
LEDs: front panel HT
level softkey HT
Index
GS = Getting Started Guide HT = Online Help
OP = Operator's Guide (press (Help) key)