Key Reference
Symbols
Chapter 598
ΦM Tone 2 Ampl Percent Of Peak
Supported PSG-A Series
This softkey enables you to adjust the amplitude of the alternate frequency as a
percentage of the peak LF analog modulation amplitude. For example, if the tone 2
amplitude is set to 30.0% of the total amplitude, then the primary frequency is 70.0% of
the total amplitude.
Default 50.0%
Range 0.1%
−
99.9%
Location Page 238
Remarks This is applicable for the dual-sine function only.
ΦM Tone 2 Rate
Supported PSG-A Series
This softkey enables you to set the internal modulation frequency for the phase
modulation tone 2 rate of the dual-sine waveform.
Default 400.0 Hz
Range 0.5 Hz
−
1.0 MHz (minimum increment is 0.5 Hz)
Location Page 238
Remarks This key is coupled to the
ΦM Stop Rate softkey in the
Φ
M swept-sine
menu. Any value set for
ΦMTone2Rate is reflected in the ΦMStopRate
softkey.
To Next Page
Loading...
Need help?
General
