Key Reference
S
Chapter 5216
Store Ref Osc Setting
Supported All
This softkey enables you to store the current coarse and fine reference oscillator
adjustment settings. Refer to the calibration guide for more information.
Preset N/A
Range N/A
Location Page 248
Remarks This adjustment is intended for use by service personnel.
Sweep
Supported All
Use this softkey to access a menu of choices that enables you to configure the sweep
parameters. In this menu you can choose to sweep frequency only, amplitude only, or
both frequency and amplitude. You can also choose to turn off all sweep functions.
Sweep Direction Down Up
Supported All
This softkey enables you to change the direction of the sweep. Choose Up to sweep from
the first point in the list sweep to the last point, or from the step sweep start frequency
and amplitude to the stop frequency and amplitude. Choose Down to reverse the
direction of the sweep.
Preset Up
Choices Down or Up
Location Page 245
Remarks None
Preset Off
Choices Off Freq Ampl Freq & Ampl
Location Page 245
Remarks None
To Next Page
Loading...
Need help?
General
