Key Reference
S
Chapter 5214
State
Supported All
This softkey enables you to specify that only signal generator instrument state files be
listed in the catalog of files currently displayed.
Preset N/A
Range N/A
Location Page 249
Remarks None
Step Dwell
Supported All
This softkey enables you to set the dwell time for each point of a step sweep. The dwell
time is the amount of time the sweep is guaranteed to pause after setting the frequency
and power for the current sweep/list point.
NOTE The dwell time does not begin until the signal generator has settled for the
current frequency and/or amplitude change. When the signal generator
has settled, a trigger signal is transmitted through the rear panel
SOURCE SETTLED OUTPUT connector.
Preset 2.0 msec
Range 1.0 msec
−
60.0 sec (in 1.0 msec increments)
Location Page 245
Remarks Dwell time is used when the point trigger is set to
Immediate.
To Next Page
Loading...
Need help?
General
