Service Guide N5242-90001 3-3
PNA Series Microwave Network Analyzers Tests and Adjustments
N5242A Information in This Chapter
Preliminary Checks
Performing the operator’s check.
Checking your test cables.
Perform these checks before performing system
verification.
Page 3-10
System Verification
What the system verification does.
How to perform the verification test.
How to interpret the results.
Page 3-19
Performance Tests
a
A brief summary of each performance test:
• Source Maximum Power Output Test
• Source Power Linearity Test
• Frequency Accuracy Test
• Trace Noise Test
• Receiver Compression Test
• Noise Floor Test
• Calibration Coefficients Test
• Dynamic Accuracy Test
Page 3-28
Adjustments
b
Setups and procedures for adjusting your analyzer:
• 10 MHz Frequency Reference Adjustment
• IF Gain Adjustment
• Synthesizer Bandwidth Adjustment
• Source Adjustment
• Receiver Adjustment
• Receiver Characterization
• EE Default Adjustment
Page 3-35
a. These performance tests are included in the analyzer’s firmware for Options 897 and
898.
b. These adjustments are included in the analyzer’s firmware on all models and options.
Section Title Summary of Content Start Page
To Next Page
Loading...
