Appendix A Specifications
124 Series N6700 User’s Guide
Agilent Models N6731A - N6735A and N6742A - N6745A
N6731A N6732A/N6742A N6733A/N6743A N6734A/N6744A N6735A/N6745A
Programming Ranges:
Voltage 20 mV – 5.1 V 20 mV – 8 .16 V 20 mV – 20.4 V 20 mV – 35.7 V 20 mV – 51 V
Current 10 mA – 10.2 A 10 mA – 6.375 A/
10 mA – 10.2 A
10 mA – 2.55 A/
10 mA – 5.1 A
10 mA – 1.53 A/
10 mA – 3.06 A
10 mA – 0.816 A/
10 mA – 1.63 A
Programming Resolution:
Voltage 3.5 mV 4 mV 5 mV 9 mV 13 mV
Current 5 mA 3.25 mA 3.25 mA 3.25 mA 3.25 mA
Measurement Resolution:
Voltage 3 mV 4 mV 10 mV 18 mV 30 mV
Current 10 mA 7 mA 3 mA 2 mA 1 mA
Output Ripple and Noise (PARD):
CC rms 8 mA 4 mA 2 mA 2 mA 2 mA
Common Mode Noise:
(from
20 Hz – 20 MHz; from either output to chassis)
Rms 1 mA 1 mA 1 mA 1 mA 1 mA
peak-to-peak < 10 mA < 10 mA < 10 mA < 10 mA < 10 mA
Over-voltage Protection:
Accuracy 0.25% + 250 mV 0.25% + 250 mV 0.25% + 250 mV 0.25% + 250 mV 0.25% + 300 mV
Maximum setting 7 V 10 V 22 V 38.5 V 55 V
Response time 50 µs from occurrence of over-voltage condition to start of output shutdown
Maximum Up-programming and Down-programming Time with full resistive load:
(time f
rom 10% to 90% of total voltage excursion)
Voltage setting from 0 V to
full scale and full scale to 0V
10 ms 10 ms 10 ms 10 ms 10 ms
Maximum Up-programming and Down-programming Settling Time with full resistive load:
(time from start of voltage change until voltage settles within 0.1% of the full-scale voltage of its final value)
Voltage setting from 0 V to
full scale and full scale to 0V
100 ms 100 ms 100 ms 100 ms 100 ms
Remote Sense Capability:
Outputs can maintain specifications with up to a 1-volt drop per load lead.
Series and Parallel Operation:
Identically rated outputs can be operated directly in parallel or can be connected for straight series
operation. Auto-series and auto-parallel operation is not available.
To Next Page
Loading...
Need help?
General
