Series N6700 User’s Guide 191
Appendix E
Compatibility
Differences – In General................................................................................192
Compatibility Command Summary ...............................................................193
Differences in Earlier Agilent N6700A Mainframes..................................197
The Agilent N6700 MPS is programmatically compatible with the
Agilent 6621A − 6629A DC power supplies. This means that you can
program the power system using the same commands that are used
to program the Agilent 662xA power supplies. The following table
describes the model mapping.
In addition to the pre-configured models shown below, Agilent 662xA
commands will also work in mainframes that contain any
combination of Agilent N675xA or N676xA power modules.
NOTE
Agilent 662xA commands will NOT work in mainframes that contain any Agilent
of N673xA/B or N674xA/B power modules. This is true even if the mainframes
also contain Agilent N675xA or N676xA power modules.
Pre-configured
Agilent MPS Model
1
Description Previous Agilent
Model
N6721A N6700A mainframe with 2 - N6752A autoranging modules 6621A
N6722A N6700A mainframe with 2 - N6752A autoranging modules 6622A
N6723A N6700A mainframe with 2- N6751A and 1- N6752A
autoranging module
6623A
N6724A N6700A mainframe with 4 - N6751A autoranging modules 6624A
N6725A N6700A mainframe with 1 - N6761A and 1 - N6762A
precision module
6625A
N6726A N6700A mainframe with 2 - N6761A and 2 - N6762A
precision modules
6626A
N6727A N6700A mainframe with 4 - N6751A autoranging modules 6627A
N6728A N6700A mainframe with 2 - N6762A precision modules 6628A
N6729A N6700A mainframe with 4 - N6762A precision modules 6629A
1
These Agilent MPS models are no longer orderable.
This appendix also contains a section describing how the earlier
Agilent N6700A mainframes are different from the Agilent N6700B
mainframes, which are the primary focus of this manual.
To Next Page
Loading...
Need help?
General
