IV U8001A/U8002A User’s and Service Guide
General Safety Information
The following general safety precautions must be observed during all
phases of operation, service and repair of this instrument. Failure to
comply with these precautions or specific warnings elsewhere in this
manual violates safety standards of design, manufacture and intended use
of the instrument. Agilent Technologies assumes no liability for
customer’s failure to comply with these requirements.
• Do not use the device if it appears damaged or defective.
• Observe all markings on the device before connecting any wiring to the
device.
• Do not operate the device in the presence of flammable gases or fumes.
• Do not install substitute parts or perform any unauthorized modification to
the device.
• Use only the power adapter provided by the manufacturer to avoid any
unexpected hazards.
• Use the device with the cables provided.
• Repair or service that this not covered in this manual should only be
performed by qualified personnels.
To Next Page
Loading...
Need help?
General
