75
Configuring the Station
4.2.4 Email Event Trigger
Set the email event trigger which initiates the message sending process. Configure the email event trigger for each
destination address.
■ Error
■ Station Restarted
■ Subject
Description Send email when a communication error has occurred.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description Send email when the station has reset.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description Set the Subject of email per Event Trigger.
Settings 1 - 64 alphanumeric characters
Default values —
Important
• "UTF-8" encoding is used for "Subject." Depending on the email client, the characters may appear incorrectly. To avoid this,
set the encoding method to "UTF-8."
To Next Page
Loading...
