AJA BRIDGE LIVE - Chapter 12 - Using SNMP; Example of SNMP Commands

BRIDGE LIVE Video I/O and Streaming Appliance v1.12 116 www.aja.com
Chapter 12 – Using SNMP
Example of SNMP Commands
It is possible to automate system monitoring with the Simple Network
Management Protocol (SNMP). Below is the list of commands that you may use.
NOTE: The monitoring only works while the BRIDGE LIVE is actually transcoding. You will
not see a correct response if the system is idle.
CPU utilization
snmpwalk -v2c -cpublic <IP> .1.3.6.1.4.1.2021.11.9
GPU utilization
snmpwalk -v2c -cpublic <IP> .1.3.6.1.4.1.50087.1.1.4.1.3
Available GPUs
snmpwalk -v2c -cpublic <IP> .1.3.6.1.4.1.50087.1.1.4.1.2
Inbound streams
snmpwalk -v2c -cpublic <IP> .1.3.6.1.4.1.50087.1.2.2.1
Outbound streams
snmpwalk -v2c -cpublic <IP> .1.3.6.1.4.1.50087.1.2.3.1
Dropped frames
snmpwalk -v2c -cpublic <IP> .1.3.6.1.4.1.50087.1.2.3.1.8
Overall status
snmpwalk -v2c -cpublic <IP> .1.3.6.1.4.1.50087.1.1.3.1
Network received data
snmpwalk -v2c -cpublic <IP> .1.3.6.1.2.1.2.2.1.10
Network transmitted data
snmpwalk -v2c -cpublic <IP> .1.3.6.1.2.1.2.2.1.16
Network interfaces
snmpwalk -v2c -cpublic <IP> .1.3.6.1.2.1.2.2.1.2