AJA FS3 - IP Address; Netmask; Default Gateway

FS3 Frame Synchronizer/Converter v1.1r1 75 www.aja.com
IP Address
IP Address determines the static IP address used by the FS3 for TCP/IP networking.
(Networking is discussed in Chapter 3, Network Connection.) Consult your
network administrator about how to set this value.
Variable If IP Address Type is set to DHCP, the IP address is set automatically by
the network DHCP server and cannot be entered here.
If IP Address Type is set to Static, enter an IP address compatible with
your LAN here. Also enter a netmask and default gateway address
in the following two parameters. Click Apply when you are ready to
apply all three entries to change the FS3’s network addressing.
If IP Address Type is set to DHCP and there is a DHCP failure, the IP
address is set to the static IP address. The default static IP address is
192.168.0.2
Netmask
Netmask determines the subnet mask used by the FS3 for TCP/IP networking.
Variable Enter a subnet mask compatible with your LAN. This is only needed
for Static IP congurations. The factory default Subnet Mask is
255.255.255.0
If IP Address Type is set to DHCP, the Subnet Mask is set by the DHCP
server and cannot be changed by the user.
Default Gateway
Default Gateway determines the gateway or router used on your LAN for TCP/IP
networking.
Without a properly configured default gateway (whether you have a router/
gateway or not), the FS3 will be unable to see other AJA FS devices on the
network, although you may still be able to control this FS3 via a web browser.
Also, without a proper gateway defined, the discovery feature on the Network
web page will not work correctly and list other FS devices on the network.
Variable Enter a default gateway or router address. This is only needed for
Static IP congurations. The factory Default Gateway is 192.168.0.1.
If IP Address Type is set to DHCP, the Default Gateway is set by the
DHCP server and cannot be changed by the user.