Section 6: Sampling and editing sounds
147
The transfer may take as long as a few minutes. When finished, the
previous screen status will be re-displayed. If a transmission error occurs, or
if the sample dump is cancelled by the other sampler, the dump will be
cancelled and the previous screen will be re-displayed. If you wish to cancel
the sample dump, press the <Cancel send> soft key.
NOTE: It is not necessary to press <Send> to initiate the outgoing midi
sample dump. If the MPC60 receives a "dump request" message from the
external sampler at any time, it will immediately display the "Sending midi
sample dump" message and begin sending the requested sound to the
external sampler. (The DRUM field will immediately change to display the
requested drum.) Further, if a sample dump is received while the "Receive
midi sample dump" screen is showing (described in the previous section), the
screen will immediately change to the "Send midi sample dump" screen and
begin sending the data. Also, the MPC60 responds to incoming "dump
request" messages on all channels- it doesn't matter what channel the
incoming message is sent on.
• SOFT KEY 2 - <Send/recv>:
Pressing this soft key causes the "Receive midi sample dump" screen to be
displayed, described in the previous section. Pressing it again returns to the
"Send" screen.
To Next Page
Loading...
Need help?
General
