Section 4:Editing sequences
91
The on-screen fields are:
• The NUMBER OF BARS field:
This is the number of blank bars to be inserted.
• The TIME SIGN field (time signature):
This is the time signature of the bars to be inserted. This is actually two
fields- one for each part of the time signature. The range of the first part is
from 1 to 31; the second part is a "choice" field with 4 selections: 4, 8, 16,
and 32.
• The INSERT BEFORE BAR field:
This field specifies the bar number which the new bars will be inserted
before. To insert bars after the end of the sequence, enter here the number
of the bar which is one higher than the last bar of the sequence.
• SOFT KEY 1- <Execute>:
Pressing this soft key performs the insertion according to the above
displayed parameters.
NOTE: If the sequence is set to loop to an earlier bar (in the time
signature / ending status screen) and the new bars are inserted before
the loop bar, causing the sequence to now loop to a different place, the
bar number specified in the LOOP field will automatically be adjusted to
compensate for the insertion.
4.3.4 Deleting bars from within a sequence
This function allows you to delete a specified number of bars from the
active sequence. To use this function, press option 4 from the EDIT
screen and the following screen will be displayed:
To Next Page
Loading...
Need help?
General
