Section 7: Saving to l loading from Disk 161
7.6 Saving a Parameter file
The settings of most of the MPC60's data fields which are not normally
saved to disk are retained after power is removed, so that you don't have to
set them again every time you turn the power on. This function allows you
to save a special file called a "Parameter file" (file extension: "PAR") which
contains the current settings of these data fields.
The following is a list of the data fields which are retained after power
is removed, and which are saved within parameter files:
(Play/record screen)
• Solo mode on/off
• 8 character names for all 64 midi channels
(Locate screen)
• Markers A, B, and C
(Tempo screen)
• Tempo source select
• Master tempo
• BPM/FPB
• Frames/sec
• Tap averaging
(Sync screen)
• Sync input mode
• Shift sync early
• Midi input select
• 1/4 note click sync starts at current bar / bar 1
• Sync output mode FSK24/PULSE96
• Midi clock output 1/2/3/4/off
(Generate SMPTE screen)
• Starting SMPTE number
(Mid-sequence tempo changes)
• Tempo changes on/off
(Create new sequence screen)
• Time signature
• Number of bars
• Loop on/off
• Loop bar
• Tempo
• Midi channel, out
ut
ort assi
nments for 99 tracks
To Next Page
Loading...
Need help?
General
