Section 7: Saving to l loading from Disk
165
7.7 Loading, erasing or renaming files
This function is used to either load, erase or rename any files on the
currently inserted disk. In the case of a load, depending on the file
extension, subsequent screens will guide you to load the file into the proper
place.
From the disk screen, type 6 to select LOAD/ERASE/RENAME and the
following screen will be displayed:
To select a file for either loading, erasing or renaming, use the DATA
CONTROL. For every click of the DATA CONTROL, a different file
from an alphabetical list of files on the disk will be displayed in the FILE
field, with its size (in bytes) displayed in the SIZE field. In the lower half of
the screen are two fields showing the available memory in both the
sequence memory and the sound memory. By comparing the file size to the
available memory, you will be able to see if there is enough space available
to load the selected file.
Loading files:
• If a SEQ file is selected and <Load it> is pressed, the following screen
will be displayed, asking you to select the sequence number to load the file
into:
Select the sequence number to load the file into, then press <Load file>.
The lowest numbered empty sequence is selected by default. After the file
is loaded, the previous screen is re-displayed.
To Next Page
Loading...
Need help?
General
