164
To save a parameter file:
1. Assign the 16 character name for the parameter file to be saved. To
name the file, use the same method as used to name sequences:
A) Rotate the DATA CONTROL one step in either direction to
change the alphabetic keys to their letter functions.
B) Type in the new name, followed by ENTER.
There are two on-screen fields to determine whether there is enough space
on disk to save the file: SIZE and DISK SPACE AVAILABLE. SIZE
displays the size (in bytes) of the file; DISK SPACE AVAILABLE displays
the available space (in bytes) on the disk currently inserted in the disk drive.
The parameter file should be smaller than the disk space available for the file
to fit on the disk.
2. Press SOFT KEY 1, <Save it to disk>, to save the sequence file to disk.
The file extension of parameter files is "PAR". After the file is saved, the
"Save Parameters" screen remains so that you can save another parameter
file if desired.
NOTE: If you attempt to save a file to a disk which already contains a file of
the same name, the lowest 2 lines of the screen will change to the following:
If you press SOFT KEY 1, <Yes>, the existing disk file will be
overwritten by the file you are saving. If you press SOFT KEY 2,
<No>, the save operation is cancelled and the previous screen is
redis
layed.
To Next Page
Loading...
Need help?
General
