Section 4:Editing sequences
93
The on-screen fields are described below:
• The SEQUENCE field (in the COPY ALL TRACKS FROM section):
This field is used to specify the sequence number to be copied from.
• The FROM BAR and TO BAR fields:
These fields set the range of bars to be copied from. FROM BAR sets
the 1st bar which is to be copied, and TO BAR sets the end of the region
to be copied (the bar number following the last bar to be copied).
• The SEQUENCE field (in the COPY ALL TRACKS TO section):
This field is used to specify the sequence number to be copied to.
• The COPIES field:
This field specifies the number of copies of the specified data will be
inserted into the insertion point. Normally, this would be set to 1.
• The INSERT BEFORE BAR field:
This field specifies the bar number which the copied data will be inserted
before. To insert the bars after the end of the sequence, enter here the
number of the bar which is one higher than the last bar of the sequence.
• SOFT KEY 1- <Execute>:
Pressing this soft key performs the copy according to the entered
parameters.
NOTE: If the sequence is set to loop to an earlier bar (in the time
signature / ending status screen) and the copied bars are inserted before
the loop bar, causing the sequence to now loop to a different bar, the bar
number specified in the LOOP field will automatically be adjusted to
compensate for the insertion.
4.3.6 Copying a single track to another area or merging it with
other data
This function permits the copying of all events within a specified
re
ion on a sin
le track to a different
oint on the same or anothe
To Next Page
Loading...
Need help?
General
