92
The on-screen fields are:
• The FROM BAR, field:
This is the 1st bar to be deleted.
• The TO BAR field:
This field specifies the end of the region to be deleted (the bar number
following the last bar to be deleted). For example, to delete bars 3 and 4,
you would enter a 3 in the FROM BAR field and a 5 in the TO BAR field,
because bar 5 is the end of the region to be deleted. This field cannot accept
a value less than that of the FROM BAR, field.
• SOFT KEY 1- <Execute>:
Pressing this soft key performs the above specified deletion.
NOTE: If the sequence is set to loop to an earlier bar (in the time signature
/ ending status screen) and the deleted bars are before the loop point,
causing the sequence to now loop to a different place, the bar number
specified in the LOOP field will be automatically changed to compensate
for the insertion.
4.3.5 Copying a section, including al! tracks, and inserting it
elsewhere
This function allows you to copy a specified range of bars from one
sequence and insert it into any other point within the same sequence or any
other sequence. In this form of the copy function, all tracks are copied, and
this data is inserted
into the new location. In this mode of copying, the
overall length of the sequence will always be increased by the copy. To use
this function, select option 5 from the EDIT screen, and the following
screen will a
ear:
To Next Page
Loading...
Need help?
General
