190
2. Set the SYNC INPUT LEVEL control on the rear panel to
about halfway.
3. Press the TEMPO/SYNC key, then press the <Sync
Screen> soft key, and the sync screen will appear:
4. Set the MODE field (Sync input section) to FSK24. 5. Press the MAIN
SCREEN key. 6. Record the parts to be overdubbed into the MPC60. 7.
Rewind the tape to the point at which you started recording the sync tone. 8.
Play the tape. Once the tape reaches the point at which you started playing
the MPC60 while recording the sync tone, the MPC60 will start playing its
new parts in perfect sync. The current tempo setting is not used - tempo is
provided from the sync tone on tape. To use FSK24, you must always start
the tape from the beginning of the recording as in this example.
NOTE: If the MPC60 doesn't respond to the sync signal, try adjusting the
SYNC INPUT LEVEL control on the rear panel. Find the lowest setting at
which the MPC60 responds, then increase the level by about 1/4 turn.
To play back a "Song" (Song mode) in sync to the FSK24
signal:
To play back a "Song" in sync to the FSK24 signal, follow the above
instructions, except select the SONG MODE screen before receiving the
FSK24 signal. This way, the active song will play instead of the active
sequence.
To Next Page
Loading...
Need help?
General
