Akai MPC 60 User Manual

Section 8: Syncing to tape and other devices
193
3.Set the MODE field (Sync input section) to MIDI CLOCK W/SONG
POINTER if you want to receive midi clock and song pointer messages. If
you want to ignore any incoming song pointer messages, set it to MIDI
CLOCK
4.Set the MIDI INPUT field to 2.
5.Press the MAIN SCREEN key.
6.Create your sequence on the MPC60.
7. Now, start the external device and the ASQ10 will automatically play in
sync. If Song Position Pointer messages are not being used, you must
position each device at its start before playing the master.
To play back a "Song" (Song mode) in sync to the Midi
Clock:
To play back a "Song" in sync to the Midi Clock signal, follow the above
instructions, except select the SONG MODE screen before receiving the
Midi Clock signal. This way, the active song will play instead of the active
sequence.

Akai MPC 60 Specifications

General

Manufacturer	Akai
Model	MPC 60
Release Year	1988
Sampling Rate	40 kHz
Bit Depth	12-bit
Polyphony	16 voices
Memory	750 KB (expandable to 1.5 MB)
Storage	3.5" floppy disk drive
Type	Sampler/Sequencer
Sequencer	Yes
Pads	16 velocity-sensitive pads
MIDI	In/Out/Thru
Maximum Sampling Time	13.1 seconds
Display	LCD
Outputs	8 individual outputs, stereo output
Inputs	2 inputs