Section 4:Editing sequences
95
• The COPIES field:
This field specifies the number of copies, end onto end, which are to be
added into the new sequence. This is normally "1".
• The START COPY AT field:
The copied data may be added into the destination sequence and track
starting at any location. This field specifies the starting location for the
copied data to be placed. This is a BAR.BEAT.CLOCK type field, allowing
the copied data to be placed at any location, in increments as small as one
clock.
• The MODE field:
This is a choice field with 2 options:
1. REPLACE:
In this mode, all existing events in the destination track are
replaced by the newly copied data - the existing events are
overwritten.
2. MERGE:
In this mode, the copied data is merged, or added, into the
existing events.
• SOFT KEY 1- <Execute>:
Pressing this soft key performs the copy as specified in the above fields.
NOTE 1: This function provides a way to shift the timing of tracks forward
or backward by any amount. To do this, simply copy a track to itself, but
slightly earlier or later. This provides an advantage over the "Shift timing"
function (in the TIMING CORRECT screen) which cannot be used without
simultaneously applying timing correction to the track.
NOTE 2: If an attempt is made to copy events from a "drums" track to a
"non-drums" track (or vice versa), the following warning screen will
appear, informing you that it cannot be done:
Pressing the <Cancel> soft key will return to the "Edit Sequence" menu
screen.
To Next Page
Loading...
Need help?
General
