Akai QZ-503R Series

1 Press the TUNER button until the FM band is se-
lected.
2 Press the PTY button.
The PTY indicator will flash on the system FL display.
If the PTY signal is being sent by the station, the
programme type (“NEWS’ etc.) will be displayed. If it is
not being sent “NONE” will appear.
3 Press the SELECT button repeatedly to select the
type of programme that you want to search for
(ROCK for example).
4 Press the PTY button again.
“PTY” will appear on the function display and PTY search
will begin. Every time a station is received the TUNED
indicator will light and the frequency will be displayed.
PTY search will continue until the type of programme
being searched for is tuned in.
If you selected NONE in step 3, pressing the PTY but-
ton will cancel PTY search. The PTY mode can be can-
celled by pressing the CLEAR button.
Note:
© If the programme type being searched for is not found,
PTY search will continue once through all the frequencies
and stop at the frequency where it was started.
The TP search function searches for stations that are broad-
casting traffic information.
1 Press the TUNER button until the FM band is se-
lected.
2 Press the TP button.
“TP” will appear on the function display and the TP indi-
cator will flash. TP search will begin and TUNED will
light every time a station is received. TP search will con-
tinue until a station broadcasting traffic information is
found.
Note:
© TP search will continue once through all the frequencies
of the band, searching for a TA (Traffic Announcement Iden-
tification) signal. If no TA signal is found, TP search will
continue once again through all frequencies searching for
a TP (Traffic Programme Identification) signal. If no sig-
nals are found TP search will stop at the frequency where
it started.
The AF search function searches for alternative frequencies
for the station that you are listening to in order to provide the
best reception. Not all stations have alternative frequencies.
The AF indicator lights on the system FL display when a
station that has alternative frequencies is tuned in. If this
indicator is not lit the following procedure will have no effect.
M@ Press the AF button.
“AF” will appear on the function display, the AF indicator
will flash and the alternative frequency will be selected.
CT adjust function
The CT adjust function adjusts the system's clock to the time
being sent by the station you are listening to.
Press the TUNER button until the FM band is se-
lected.
ech,
Press the CT button.
“CLOCK’ will appear on the system FL display and the
clock will be adjusted.
Even if the RDS indicator is lit, if no CT data is being
sent, “NO CT” will appear.
Station information display
Whenever TUNER input is selected the following station in-
formation will be automatically displayed on the system FL
display.
NO
Frequency or preset channel
RDS station name
The remote control's DISPLAY button can also be pressed
repeatedly to scroll through the station information.
Station information will change as follows.
Frequency and preset channel
RDS station name
PTY display
Clock display
Note:
e The RDS station name and PTY display will only appear if
they are being sent by the station.
13