Akai QZ-503R Series

Ld
Precautions
Warning
To prevent fire or shock hazard, do not expose this appli-
ance to rain or moisture.
1-En
Power requirements
Power requirements for electrical appliances differ from
area to area. Please ensure that your unit meets the re-
quirements in your area.
If in doubt, consult a qualified electrician.
220-230V, 50Hz for Europe
About the power switch
This unit is not equipped with a primary power switch.
Even when the amplifier’s © / 1 STANDBY / ON button is
off, the power supply to the unit is not completely turned
off. If you wish to turn the power off completely, discon-
nect the power cord from the AC outlet.
4-En
Make Your Contribution to Protect the Environ-
ment
Used batteries with the ISO symbol for
recycling as well as small accumulators &
(rechargeable batteries), mini-batteries
(cells) and starter batteries should not be thrown
into the garbage can.
Please leave them at an appropriate depot.
29A-En
CLASS 1 LASER PRODUCT
This product contains a low power laser device. To en-
sure continued safety, do not remove any covers or at-
tempt to gain access to the inside of the product. Refer
any servicing to qualified personnel.
CLASS 1. LASER PRODUCT
KLASS'!
LASER LAITE
KLASS 1 LASER APPARAT
CAUTION ; invisiaie LASER RADIATION WHEN OPEN
AND INTERLOCKS DEFEATED. AVOID EXPOSURE TOBEAM
ADVARSEL ; usynuia LASERSTAALING’ VEO As-
NING NAR SIKKERHEDSAFBAYOERE ER UDE AF FUNKTION
UNOGA UDSATTELSE FOR STRALING.
VARO ; AVATTAESSA JA SUOJALUKITUS OHITET-
TAzseA GLET ALTTHNA NAKYMATTOMALLE LASERSATE!-
rie KATSO SATEESEEN !
INING ; OSYNLIG LASERSTRALNING NAA DENNA
VARI
DEL AR OPPNAD OCH SPARREN AA URKOPPLAD.
BETAAKTA EJ STRALEN !
PRECAUTION
Never disassemble or
modify the appliance in
any way.
RISK OF FIRE OR ELEC-
TRIC SHOCK
Avoid using the appliance where
there is a lot of moisture and do
not expose to water.
a
RISK OF FIRE ORELECTRIC | EN
SHOCK
e {fwateris spilled on the system, disconnect the power
cord at once and consult your dealer.
Never touch the power cord’s plug
with wet hands.
RISK OF ELECTRIC SHOCK
Never put anything, especially metal NMG 2 SO
into the system. Seo. yo
Se
RISK OF FIRE OR ELECTRIC
SHOCK
Use a household AC power source
only.
Never use a DC power source.
RISK OF FIRE OR ELECTRIC
SHOCK
Avoid using aerosol sprays near ~
the system.
RISK OF FIRE
There should be at least 10cm bee
space between the top, rear
and sides of the system.
tal