Akai QZ-503R Series

TAKE CARE!
Take care that children do not put
their hands in the disc slot, as this
may cause injury.
Do not place anything heavy on top
of the system.
Make sure that the system is well
ventilated and do not place any-
thing on top of the ventilation holes.
To avoid damage to the internal
circuits and the external surface,
keep the system away from heat
(stoves, direct sunlight, etc.).
Place the system on a flat and
solid surface.
If you do not plan to use the sys-
tem for a long period
—
of time, unplug the power cord. aye
| —-
o (oye
“(
Rema Gane:
(AR,
tremely hot, cold, humid or dusty Yy ee vay
Avoid using the system in ex-
a
LL
places.
ig
To avoid damaging the finish, never use paint thinner
or other similar chemicals to clean the system.
Avoid using the system near appliances generating
magnetic fields. :
Avoid using the system near fluorescent lamps as this
may shorten the operating range of the remote control
unit.
When transporting
Avoid violent shocks to the system during packing.
Avoid moisture condensation
If the temperature of the room where the stereo system is
placed is suddenly increased, or if the system is trans-
ported from a cold location to a warm one, condensation
(tiny droplets of water) may form on the MD recorder/CD
player's laser pickup lens or the cassette deck’s transport
section (such as capstan and heads), preventing correct
playback. If excess condensation forms on the compact
disc or inside the CD player/MD recorder, operation of
the CD player/MD recorder will not resume until the con-
densation has had ample time to dissipate. If condensa-
tion forms inside the cassette deck, the tape will stick to
the heads and be ruined, or it will not be transported prop-
erly. In either case wait 30 minutes to one hour before
using the stereo system.
Keep the cabinet clean
© Clean the cabinet with a soft, dry cloth.
@ If the cabinet is excessively dirty, clean it with a mild
detergent.
© Never use paint thinner, etc., to clean the cabinet as
this may damage the finish.
In case of malfunction
A large amount of static electricity may cause this stereo
component system to malfunction or stop functioning com-
pletely. In this case, the micro-processor must be re-set
to its initial operating mode as follows.
Unplug the power cord from your household AC out-
let for at least 1 minutes, then reconnect it.
The micro-processor will be reset.