2.7 Do Not Service or Adjust Alone
WARNING
While in the battery circuit, do not attempt internal service or adjustment of this
equipment unless another person, capable of calling for or rendering first aid and
resuscitation, is present.
2.8 Do Not Substitute Parts or Modify Equipment
Due to the possible danger of introducing additional hazards, do not install substitute parts or
perform any unauthorized modification to the product. If necessary, request service and repair
from Albércorp. to ensure that safety features are maintained.
2.9 Ensure Rack/Chassis/Shelving/Mounting Stability
To ensure stability of the test bay, place heavier instruments near the bottom of the rack. Check
the location of all equipment (including PCs) for stability. Make sure cabinets are well mounted.
2.10 Radiated Immunity
If and when subjected to abnormally high RFI fields they may affect the operation of the
equipment.
2.11 Insulation Rating for Wires
Use only when supplied with the installation kit.
2.12 Ventilation
Never block equipment ventilation openings. The equipment must have adequate ventilation to
prevent equipment overheating. If using a cabinet, allow at least 8" clearance on all sides of the
cabinet for ventilation. Never block ventilation ports, and ensure the equipment is operated
within the temperature and humidity ranges found in the Ventilation Guide Table and within the
specifications:
range:
5°C to 40°C
41°F to 104°F
Humidity
range:
(non condensing) at 5
C to 31
C
0% to 50% RH
(non condensing) at 32°F to 40°C
2.13 Drawings
Drawings and Figures in this manual may be for reference only or may be superseded by later
drawings. For the latest information and revision, refer to the drawings supplied with the system.
Reference drawings are located in the rear of the manual.
2.14 Warning
WARNING
Denotes a hazard. It calls attention to a procedure, practice, or condition, which, if not
correctly performed or adhered to, could result in personal injury or death. Do not
proceed beyond a WARNING symbol until the indicated conditions are fully understood
and met. Refer to enclosed documents as well as OEM documentation.
To Next Page
Loading...