Alber BDS-40 - Alarm Contacts and Remote Alarm Reset; Figure 43. Section 6.3 of Multitels FCCP Installation Manual

Begin System Installation
4200–045
31
6/5/2017
Figure 43. Section 6.3 Of Multitel’s FCCP Installation Manual Pg. 39
7.2.8 Alarm Contacts And Remote Alarm Reset
There are two sets of Form C alarm contacts, labeled Critical and Maintenance, on the BDS–40
Base Unit rear panel. Each set of connections has a COM (Common), NC (Normally Closed),
and NO (Normally Open) terminal. These alarms are BMDM program configurable under Setup
on the Main Menu.