1 LEGAL INFORMATION
1.1 FCC DECLARATION OF CONFORMITY
This notice is applicable to Product/System/Hardware/Equipments with the Radio Frequency RF
headset communication option installed for Bluetooth
®
–based communication.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
(i) This device may not cause harmful interference, and
(ii) This device must accept any interference received, including interference that may
cause undesired operations.
1.2 REGULATORY INFORMATION
1.2.1 Type Of Service
The MPM Series and the BDS Series Albércorp. Product/System/Hardware/Equipment is
designed to be used on standard device telephone lines. It connects to the telephone line by
means of a standard jack called the USOC RJ11C or USOC FJ45S. Connection to telephone
company provided coin service (central office implemented systems) is prohibited. Connection
to party line service is subject to state tariffs.
1.2.2 Telephone Company Procedures
The goal of the telephone company is to provide the user with the best service it can. To do this,
it may occasionally be necessary for the company to make changes in its equipment,
operations, or procedures. If these changes might affect the Original Purchasing End User’s
service or the operation of the Original Purchasing End User’s equipment, the telephone
company will give the Original Purchasing End User notice, in writing, to allow the Original
Purchasing End User to make any changes necessary to maintain uninterrupted service.
In certain circumstances, it may be necessary for the telephone company to request information
from the Original Purchasing End User concerning the equipment that the Original Purchasing
End User has connected to the telephone line(s). Upon request of the telephone company,
provide the FCC registration number and the Ringer Equivalence Number REN; both of these
items are listed on the equipment label. The sum of all the RENs on the telephone line must be
less than five in order to assure proper service from the telephone company. In some cases, a
sum of five may not be useable on a given line.
1.3 SERVICE
Proper installation and testing are essential to the correct functioning of the system. If the user
have questions, contact Albércorp./ Albér at 954–377-7101 or fax 954-377-7042. Request
monitor assistance. Except as explained in this manual, do not attempt to service Albér
equipment.
WARNING:
Opening the equipment may expose personnel to dangerous voltages.
To Next Page
Loading...