EMERGENCY SHUTDOWN SWITCH/
2.15 Caution
CAUTION
This symbol/box denotes a hazard. It calls attention to an operating procedure, or
condition, which, if not correctly performed or adhered to, could result in damage
to or destruction of part or all of the product or permanent loss of data. Do not
proceed beyond a CAUTION symbol until the indicated conditions are fully
understood and met. Refer to enclosed documents.
2.16 Note:
NOTE:
This symbol/box contains important information.
2.17 Safety Symbols
approved by Underwriters Laboratories
warning
protective earth (ground) terminal
caution
frame or chassis terminal
notice
3 EMERGENCY SHUTDOWN SWITCH/
DISCONNECT DEVICE
In most cases, the three prong AC cord from the cabinet, which connects to the 115VAC or
230VAC receptacle, is considered the primary disconnect device.
3.1 BDS–40 Disconnect Device
The power switch on the rear of the BDS 40 base unit is considered the primary disconnect
device.
NOTE:
Different systems may have different disconnect procedures, please refer to the
installation instructions or contact Albércorp.
To Next Page
Loading...