Any adjustment, maintenance, or repair of this product must be performed by qualified
personnel or contact a customer engineer through Albércorp., 954-377-7101 Request
assistance. Never allow unauthorized personnel to operate the equipment. Only qualified and
trained personnel are to perform the operations described in this manual. Calibration must be
performed by technically qualified trained personnel.
2 SAFETY INFORMATION
All safety information within must be read, understood and strictly adhered to before installing,
powering up or using the equipment/software; i.e. the system.
The following general safety precautions must be observed during all phases of operation,
service, and repair of this product. Failure to comply with these precautions or with specific
WARNINGs elsewhere in this manual violates safety standards of design, manufacture, and
intended use of the product. Albércorp., assumes no liability for the customer's failure to comply
with these requirements.
WARNING:
Use of this system in a manner not specified could compromise the designed–in safety.
2.1 General
For Safety Class 1 equipment, e.g. equipment provided with a protective earth terminal, an
uninterruptible safety earth ground must be provided from the main power source to the product
input wiring terminal or supplied power cable. The protective features of this product may be
impaired if it is used in a manner not specified in the operation/installation instructions. This
manual describes the general installation and use of the system. If the system has features or
accessories not described in this manual, contact Albércorp. at 954- 377-7101 or fax 954- 377–
7042.
2.2 Before Applying Power
Check configuration and drawings. Double–check all connections. Verify that the system is set
to match available voltage, the correct fuses are installed, and all safety precautions are taken.
NOTE:
Notice the system’s external markings described under Safety Symbols.
WARNING
High voltage or current may be present inside the equipment and on the equipment
terminals.
Observe system’s external markings and all electrical safety precautions when removing
and installing equipment covers, when connecting leads, and when making adjustments.
Never energize the cabinet or any component with 115VAC (or 230VAC if applicable) or
battery voltage until after the installation is complete.
Never exceed equipment voltage, power ratings, or capabilities.
To Next Page
Loading...