Table Error Messages (continued)
Indication in
the display
Acoustic sig-
nal on the
wheel
Repetition
Acoustic
signal
Error description What to do
every 5
seconds
The charger plug is inserted in the charger
socket but no charge current is flowing.
Check the operational readiness of the
charger.
Possible defect on the charger or wheel;
repair is then required.
every 10
seconds
The battery pack was charged longer than
12 hours but is not completely charged.
The charger is defective is both battery
packs are charged at the same time and
the error messages is indicated for both
battery packs.
If both battery packs are charged at
the same time and the error message is
indicated for only one battery pack, this
battery pack is defective.
Repair is required in both cases.
every 10
seconds
The charging process was terminated
because the ambient temperature
is below 0 °C
or
above 0 °C.
Charge the battery packs only at tem-
peratures
above 0 °C
and
below 40 °C.
every 10
seconds
The charge process was terminated because
one battery pack is defective.
Repair is required.
A major fault of the system is present if error messages other than those listed in the display are shown or
other signal tones than those listed sound on the wheels. Your e-motion is then no longer operational and must
be sent to the Alber factory for inspection. To prevent damage or personal injury, do not operate or use the e-
motion if a fault is present.
To Next Page
Loading...
