To Next Page

To Previous Page

ADMIN PASSWORD

This is the password for entering camera advanced setting section and by default the password is

123456.

This password can have absolute control over the detail settings. It is required to enter this

password everytime accessing the camera advanced setting. If you have multiple cameras register

to the app, each camera can have its own admin password.

DEVICE SECURITY CODE

The code required for app to remotely connect and operate the camera. The default security code

is 123456. When setup the camera, the APP will ask you to change the default security code.

This password can have access to view and operate the camera.

It is not required to enter the security code everytime accessing the camera(s). The camera security

code is saved to the app (see page-12, camera setting).

If you have multiple cameras registered to the app, each can have

its own security code.

1. Type in the old password.

Note:

If you forget the admin password, MUST reset the camera default security code (Please

refer to page-6). After reset the camera setting, which will be erased and restored to

factory default. You will need to recongure all settings.

iOS Android

Questions and Answers:

Need help?

Do you have a question about the ALC AWFB15 and is the answer not in the manual?

ALC AWFB15 Specifications

General