Alcatel-Lucent 7210 - Page 56

Initializing the System and Downloading Software
Page 56 7210 SAS-M Installation Guide
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/2
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
Hit a key within 2 seconds to change boot parameters...
Press any key.
Enter password to edit the Boot Options File
Or CTRL-D to exit the prompt
Password:
The default password is password.
You must supply some required Boot Options. At any prompt, you can type:
"restart" - restart the query mode.
"reboot" - reboot.
"exit" - boot with with existing values.
"reset" - reset the bof and reboot.
Press ENTER to begin, or 'flash' to enter firmware update...
Press Enter.
Software Location
-----------------
You must enter the URL of the TiMOS software.
The location can be on a Compact Flash device,
or on the network.
Here are some examples
cf1:/timos1.1R1
ftp://user:passwd@192.168.1.150/./timos1.1R1
tftp://192.168.1.150/./timos1.1R1
Software Image URL:
Note: The restart command can be used at any time to start off at the beginning of the menu
options.