Configuring the 7210 SAS-M
7210 SAS-M Installation Guide Page 55
the example below. Additionally, you may want to store the TiMOS image on the internal flash if
you want to boot from the flash later.
You will need the following:
• A FTP server
• TiMOS image
• A PC with a serial port and Hyperterminal
• Cable that connects the console port of 7210 SAS-M to the serial port of PC
• A network cable to connect the 7210 unit to the network
Prepare the set up as shown in the diagram above. Ensure that the console settings are set as shown
in Console Connection on page 65.
When you are done, power on the 7210 SAS-M.
Using the uplink port to boot 7210 from the network:
Resetting...OK
ø
Alcatel-Lucent 7210 Boot ROM. Copyright 2000-2009 Alcatel-Lucent.
All rights reserved. All use is subject to applicable license agreements.
Running POST tests from ROM
Testing ROM load area...done
Relocating code...Jumping to RAM
Performing second stage RAM test....passed
Board Serial Number is 'SN12345678'
Bootlog started for Version V-1.0.R1
Build V-1.0.R1 bootrom/mpc 7xxx
Built on Thu Jan 15 14:55:59 IST 2009 by builder in /builder/ws/panos/main
Since the router does not ship with a BOF, it will show the default settings.
Looking for cf1:/bof.cfg ... not found
Could not find bof.cfg on any of the local drives.
Default Settings:
-------------------------------------------------------------------------------------
------------
Contents of Boot Options File on cf1:
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/1
uplinkA-address 0
To Next Page
Loading...
