Accounting Terminate Causes
Page 228 7750 SR RADIUS Attributes Reference Guide
Accounting Terminate Causes
Table 74 specifies the different Terminate Causes generated by the SR OS in [49] Acct-Terminate-
Cause attribute.
Table 74: Accounting Terminate Causes
Code Acct Terminate
Cause
Description SR OS
1 User-Request User requested termination of service, for example, with LCP
Terminate or by logging out.
yes
2 Lost-Carrier Data Carrier Detect (DCD) was dropped on the port yes
3 Lost-Service Service can no longer be provided; for example, user's connection to
a host was interrupted.
yes
4 Idle-Timeout Idle timer expired yes
5 Session-Timeout Maximum session length timer expired yes
6 Admin-Reset Administrator reset the port or session yes
7 Admin-Reboot Administrator is ending service on the NAS, for example, prior to
rebooting the NAS.
no
8 Port-Error NAS detected an error on the port which required ending the session yes
9 NAS-Error NAS detected some error (other than on the port) which required
ending the session
yes
10 NAS-Request NAS ended session for a non-error reason not otherwise listed here. yes
11 NAS-Reboot The NAS ended the session in order to reboot non-administratively
(crash).
yes
12 Port-Unneeded NAS ended session because resource usage fell below low-water
mark (for example, if a bandwidth-on-demand algorithm decided that
the port was no longer needed).
no
13 Port-Preempted NAS ended session in order to allocate the port to a higher priority
use
no
14 Port-Suspended NAS ended session to suspend a virtual session yes
15 Service-
Unavailable
NAS was unable to provide requested service yes
16 Callback NAS is terminating current session in order to perform callback for a
new session
no
17 User-Error Input from user is in error, causing termination of session. no
To Next Page
Loading...
