Dynamic Data Service accounting
Page 220 7750 SR RADIUS Attributes Reference Guide
Dynamic Data Service accounting
This section specifies the attributes for RADIUS accounting on dynamic data service SAPs. The
attributes for RADIUS accounting of the associated control channel is identical as the ESM
accounting case (see section Enhanced Subscriber Management (ESM) accounting.
Table 68: Dynamic Data Service Accounting (description)
Attribute ID Attribute Name Description
1 User-Name The RADIUS user-name from the Dynamic Data Service Control Channel
associated with this Dynamic Data Service SAP accounting session
4 NAS-IP-Address The identifying IP Address of the NAS requesting the Authentication or
Accounting. Included when the RADIUS server is reachable via IPv4.
The address is determined by the routing instance through which the RADIUS
server can be reached:
“Management” — The active ipv4 address in the Boot Options File (bof
address <ipv4-address>)
“Base” or “VPRN” — The ipv4 address of the system interface (configure
router interface system address <address>).
The address can be overwritten with the configured source-address (configure
aaa radius-server-policy <policy-name> servers source-address <ip-
address>)
25 Class The Class attribute from the Dynamic Data Service Control Channel
associated with this Dynamic Data Service SAP accounting session
32 NAS-Identifier A string (configure system name <system-name>) identifying the NAS
originating the Accounting requests.
40 Acct-Status-Type Indicates whether this Accounting-Request marks the beginning of the user
service (Start) or the end (Stop) or reports interim updates.
41 Acct-Delay-Time Indicates how many seconds the client has been trying to send this accounting
record for. This attribute is included with value 0 in all initial accounting
messages. Attribute is omitted in accounting via configure subscriber-mgmt
radius-accounting-policy <name> include-radius-attribute no acct-delay-
time.
44 Acct-Session-Id Unique generated hexadecimal number that represents the accounting session
for this Dynamic Data Service SAP.
46 Acct-Session-Time The acct session time is started when the corresponding dynamic data service
sap is created. The acct session time is stopped when the corresponding
dynamic data service sap is deleted. When the SAP is orphaned (not deleted in
the teardown function call), the session time stops after the teardown script is
executed. In case an accounting stop is sent as a result of a failure scenario, the
acct-session-time will be zero.
To Next Page
Loading...
