RADIUS Attributes Reference
7750 SR RADIUS Attributes Reference Guide Page 57
Wholesale-Retail — Local Access Mode
Table 5: Wholesale-Retail: Local Access Mode (description)
Attribute ID Attribute Name Description
26-6 5 27-17 Alc-R etail- Serv- Id T h e s ervi c e ID of the retailer to which this subscriber host belongs.
(configure service ies/vprn <retail-service-id> subscriber-interface retail-
interface-id fwd-service <wholesale-service-id> fwd-subscriber-interface
wholesale-interface-name>). Returning an IES service ID for an IPoEv4 host
is treated as a session setup failure.
This attribute must be included together with NAS-Port-Id and an IP-address/
prefix attribute in a CoA targeting a subscriber host in a retail service.
2 6 - 6 5 2 7 - 3 1 A l c - M S A P - S e r v - I d T h e service-id (IES/VPRN) where Managed SAP’s are created.(configure
service ies/vprn <service-id>). If this attribute is omitted, use msap defaults
created under ludb or capture VPLS.(configure subscriber-mgmt local-user-
db <local-user-db-name> ppp/dhcp host msap-defaults service <service-
id> or configure service vpls <service-id sap <sap-id> msap-defaults
service <service-id>). This omitted attribute without explicit created msap-
defaults is treated as a setup failure.
2 6 -6 52 7 -3 2 A l c -M S AP - Po l ic y Ma n ag e d s ap policy-name used to create Managed SAPs and refers to the CLI
context configure subscriber-mgmt msap-policy <msap-policy-name>).
The policy contains similar parameters that would be configured for a regular
subscriber SAP. If this attribute is omitted we have to option to will fall back
to msap defaults created under ludb or capture VPLS. (configure subscriber-
mgmt local-user-db ppp/dhcp host msap-defaults policy <msap-policy-
name> or configure service vpls sap msap-defaults policy <msap-policy-
name>).This omitted attribute without explicit created msap-defaults is
treated as a setup failure.
26-6527-33 Alc-MSAP-Interface The group-interface-name where Managed SAPs are created and refers to
CLI context configure service ies/vprn subscriber-interface <ip-int-name>
group-interface <ip-int-name> policy
<msap-policy-name>. If this attribute
is omitted we have to option to will fall back to msap defaults created under
ludb or capture VPLS. (configure subscriber-mgmt local-user-db <local-
user-db-name> ppp/dhcp host msap-defaults group-interface <ip-int-
name> or configure service <service-id> vpls sap <sap-id> msap-defaults
group-interface <ip-int-name>). Strings above the Limits and an omitted
attribute without explicit created msap-defaults are treated as setup failures.
To Next Page
Loading...
