Accounting Triggered Reason VSA Values
Page 232 7750 SR RADIUS Attributes Reference Guide
(1) IP address/prefix tracking: a triggered Accounting Interim Update message notifies the
RADIUS accounting server of the acquisition or release of an IP address or prefix during the
lifetime of a session.
(2) requires host-update to be configured for session-accounting mode (configure subscriber-
mgmt radius-accounting-policy <name> session-accounting interim-update host-update)
Value Reason Description
Accounting Mode
ESM DSM
Host Session Queue
13 DSL-Line-
Attributes-
Changed
Generated when DSL-Line-Attributes values (for
example: Actual-Data-Rate-Upstream) are
received via ANCP after the PPPoE session or
IPoE binding was already established.
XX X—
14 Wlan-
Mobility-
Event
Generated when mobility triggered accounting is
enabled (configure router|service vprn <id>
wlan-gw mobility-triggered-acct interim-
update) and when a mobility event is detected (re-
authentication, accounting start, accounting
interim-update, data or Inter Access Point Protocol
(IAPP)).
X— XX
15 Persistence-
Recover
IPoE subscriber hosts can be made persistent
across node reboots: state is restored from a
persistency file located on the compact flash file
system. A triggered Accounting Interim Update
message is generated for each subscriber host that
is successfully restored.
X— X—
16 SRRP-
Switchover
Generated in dual homing scenarios by the node
switching from srrp-non-master to srrp-master
state.
XX X—
17 Nat-Port-
Range-Event
Generated when l2-aware nat port-ranges are
created and removed.
This will only be triggered if any of the attributes
outside-ip, outside-service or port-range-block is
configured as an accounting include attribute.
—— —X
Table 75: Accounting Triggered Reason (Continued)