Alcatel-Lucent 7750 - Page 28

Subscriber Host Identification
Page 28 7750 SR RADIUS Attributes Reference Guide
26-6527-10 Alc-Secondary-
Dns
The IPv4 address of the secondary DNS server for this subscribers connection
and maps to PPPoE IPCP option 131 Secondary DNS Server address or
DHCPv4 option 6 Domain Server. Is an alternative for 26-2352-2 Client-DNS-
Sec or 26-4874-5 ERX-Secondary-Dns.
Applicable in proxy scenarios only for IPoE.
26-6527-11 Alc-Subsc-ID-Str A subscriber is a collection of subscriber-hosts (typically represented by IP-
MAC combination) and is uniquely identified by a subscriber string.
Subscriber-hosts queues/policers belonging to the same subscriber (residing on
the same forwarding complex) can be treated under one aggregate scheduling
QoS mechanism. Fallback to pre-configured values if attribute is omitted.
Attribute values longer than the allowed string value are treated as setup
failures. Can be used as key in CoA and Disconnect Message. Attribute is
omitted in accounting via configure subscriber-mgmt radius-accounting-
policy <name> include-radius-attribute no subscriber-id.
26-6527-12 Alc-Subsc-Prof-Str The subscriber profile is a template which contains settings (accounting, igmp,
HQoS,...) which are applicable to all hosts belonging to the same subscriber
were [26-6527-12] Alc-Subsc-Prof-Str is the string that maps (configure
subscriber-mgmt sub-ident-policy sub-profile-map) to such an subscriber
profile (configure subscriber-mgmt sub-profile <subscriber-profile-name>).
Strings longer than the allowed maximum are treated as setup failures.
Unreferenced strings (string does not map to a policy) are silently ignored and a
fallback to pre-configured defaults is done. Attribute is omitted in accounting
via configure subscriber-mgmt radius-accounting-policy <name> include-
radius-attribute no sub-profile.
26-6527-13 Alc-SLA-Prof-Str The SLA profile is a template which contains settings (filter, QoS, host-limit...)
which are applicable to individual hosts were [26-6527-13] Alc-SLA-Prof-Str is
the string that maps (configure subscriber-mgmt sub-ident-policy <sub-ident-
policy-name> sla-profile-map) to such a sla profile (configure subscriber-
mgmt sla-profile <sla-profile-name>). Strings longer than the allowed
maximum are treated as setup failures. Unreferenced strings (string does not
map to a policy) are silently ignored and a fallback to pre-configured defaults is
done. Attribute is omitted in accounting via configure subscriber-mgmt
radius-accounting-policy <name> include-radius-attribute no sla-profile.
2 6 - 6 5 2 7 - 1 6 A l c - A N C P - S t r I n f o r m a t i o n describing the subscriber agent circuit identifier corresponding to
the logical access loop port of the Access Node/DSLAM from which a
subscriber's requests are initiated and used to associate the ANCP Circuit-Id
(info received via ANCP Port Up and Port Down) with the PPPoE/IPoE Circuit-
Id (info received via [26-6527-16] Alc-ANCP-Str and [26-3561-1] Agent-
Circuit-Id). An subscriber is ANCP associated when both strings are equal and
for associated subscribers the ingress/egress ANCP QoS rules apply (configure
subscriber-mgmt ancp ancp-policy <policy-name> and configure
subscriber-mgmt sub-profile ancp ancp-policy <policy-name>.
Table 2: Subscriber Host Identification (description) (Continued)
Attribute ID Attribute Name Description