Alcatel-Lucent 7750 - Page 35

RADIUS Attributes Reference
7750 SR RADIUS Attributes Reference Guide Page 35
26-6527-183 Alc-WPP-Error-
Code
This attribute specifies the value of the ErrCode that the system should use in a
WPP ACK_AUTH packet. This attribute can only be included in a Radius
Access-Reject packet.
26-6527-185 Alc-Onetime-Http-
Redirect-
Reactivate
An indication to reactivate a onetime http redirect filter for the host.
When received in a RADIUS CoA message,
• the filter with the value indicated by [26-6527-136] Alc-Onetime-Http-
Redirection-Filter-Id is activated.
• If [26-6527-136] Alc-Onetime-Http-Redirection-Filter-Id contains the
value 0, then the existing onetime http redirect filter id associated with the
host is removed.
• if no [26-6527-136] Alc-Onetime-Http-Redirection-Filter-Id VSA is
provided in the RADIUS CoA message, then the existing onetime http
redirect filter id associated with the host is applied.
The value of the [26-6527-185] Alc-Onetime-Http-Redirect-Reactivate VSA is
opaque. It is the presence of the VSA in a RADIUS CoA that triggers the action.
26-6527-191 Alc-ToServer-
Dhcp6-Options
This attribute contains DHCPv6 client options present in a DHCPv6 Solicit or
Request message to be passed to RADIUS in an Access-Request. Up to two
attributes are included in the Access-Request message in case that the length of
the DHCPv6 options exceed the maximum length of a single attribute (see
Limits section).
When the DHCPv6 solicit or request message is encapsulated in a Relay-
Forward message, only the inner DHCPv6 client options are copied in the Alc-
ToServer-Dhcp6-Options attribute. Options inserted by a Relay Agent are
ignored.
Attribute is included/excluded based on configure subscriber-mgmt
authentication-policy <name> include-radius-attribute dhcp6-options
For DHCPv6 triggered authentication in a Distribute Subscriber Management
(DSM) context, this attribute contains the DHCPv6 client options as sent to the
WLAN-GW. Inclusion of this attribute is configured via configure aaa isa-
radius-policy <policy-name> auth-include-attributes dhcp6-options.
26-6527-192 Alc-ToClient-
Dhcp6-Options
The value of this attribute represents DHCPv6 options encoded in a
hexadecimal format. DHCPv6 options originated by Radius are appended to the
options already present in the DHCPv6 Advertise and Reply messages towards
the client.
Passing the RADIUS obtained DHCPv6 options to the client is supported for
both DHCPv6 proxy and relay.
Only the attributes within the defined limits (see limits) are parsed and stored;
the remaining attributes are silently ignored.
Table 2: Subscriber Host Identification (description) (Continued)
Attribute ID Attribute Name Description