Mounting OS6250 Switches Assembling OS6250 Switches
OmniSwitch 6250 Series Hardware Users Guide September 2009 page 3-11
Preliminary
9/28/09
Attaching Power Supply Tray to Rear of Chassis
To secure a power supply tray to the rear of the chassis, follow the steps below.
1 Insert the two tabs at the base of the tray into the slots provided at the bottom-rear portion of the switch
chassis.
Insert Tabs Into Chassis Slots
2 Be sure that the two holes in the tray are aligned with the threaded holes in the rear panel of the
chassis and secure the tray to the switch using the two attachment screws (M3 pan head).
Skip to “Securing Power Supplies in Power Supply Tray” on page 3-12
Insert tab
Insert tab
To Next Page
Loading...
