Mounting OS6250 Switches Mounting OS6250 Switches
page 3-16 OmniSwitch 6250 Series Hardware Users Guide September 2009
Preliminary
9/28/09
Table-Mounting OS6250 Switches
General Table-Mounting Guidelines
OmniSwitch 6250 Series switches can be installed freestanding as tabletop-mounted units. If you will be
table-mounting your switch(es), refer to the important guidelines below before installing.
• When choosing a location for the switch, be sure that adequate clearance has been provided for chassis
airflow and access to the front, back, and sides of the chassis. For recommended clearances, refer to
“Recommended Clearances” on page 3-3.
• The power cord for OmniSwitch 6250 switches measures two (2) meters (approximately 6.5 feet) in
length. When table mounting the switch, be sure that the mounting location is within the reach of all
the required power sources.
Table-Mounting Installation
1 Follow the proper assembly instructions based on the configuration of the chassis and power supply
trays described in “Assembling OS6250 Switches” on page 3-5.
2 Locate the table-mount brackets provided in your ship kit and orient the brackets so that the rubber
bumpers are facing down. Attach the brackets to both sides of the switch, as shown.
3 Attach the additional mounting brackets (provided) to the rear portion of the power supply tray that
was installed at step 1 (again, so that the rubber bumpers are facing down). Attach the brackets to both the
left and right side of the tray.
To Next Page
Loading...
