Monitoring the Chassis Booting 6250 Series Switches
page 4-6 OmniSwitch 6250 Series Hardware Users Guide September 2009
Preliminary
9/28/09
Checking the Fan Status
To check the current status for all six fans in the chassis, use the show fan command. For example:
-> show fan
Chassis Fan Status
-------+---+-----------
1 1 Running
1 2 Running
1 3 Running
1 4 Running
For a complete list of output definitions for this command, refer to the OmniSwitch CLI Reference Guide.
Checking the Power Supply Status
For information on checking power supplies for OmniSwitch 6250 Series switches, refer to “Booting 6250
Series Switches” on page 4-1.
Automatic Monitoring
Automatic monitoring refers to the switch’s built-in sensors that automatically monitor operations. The
switch recieves an interrupt warning at a temprature of 75C. It sends a trap to the user and the switch
shuts down automatically when the temperature reaches 80C. Upon cooling (at 65C), the switch restarts.
Additional Monitoring Commands
CLI Commands Used for Monitoring a Chassis
show cmm Displays the basic hardware and status information for primary and
secondary management modules (if applicable).
show ni Displays the basic hardware and status information for individual mod-
ules. If the switch is a standalone, information for the stand alone
switch displays.
show module Displays the basic information for individual modules. If the switch is a
standalone, information for the stand-alone switch displays.
show module long Displays the detailed information for individual modules. If the switch
is a standalone, information for the standalone switch displays.
show module status Displays the basic status information for individual modules. If the
switch is a standalone, information for the standalone switch displays.
To Next Page
Loading...
