Mounting OS6250 Switches Mounting OS6250 Switches
OmniSwitch 6250 Series Hardware Users Guide September 2009 page 3-19
Preliminary
9/28/09
Wall-Mounting Installation
1 Follow the proper assembly instructions based on the configuration of the chassis and power supply
trays described in “Assembling OS6250 Switches” on page 3-5.
2 Locate the wall-mount brackets provided in your ship kit and orient the brackets so that the rubber
bumpers are facing down. Attach the brackets to both the left and right side of the switch, as shown.
Attaching the wall-mount brackets.
3 Attach two additional mounting brackets (provided) to the rear portion of the chassis so that the rubber
bumpers are facing down. Attach the brackets to both the left and right side of the switch.
4 Use one person to securely hold the chassis assembly in position on the wall. Mark the location of the
holes in the mounting brackets on the wall.
5 Pre-drill the wall (if required).
Recommended Wall Mount Chassis Orientation
NOTE: For wall mounting, it is recommended that the
chassis assembly is oriented sideways, with the chassis
front panel facing left, as shown in the diagram below.
Wall surface
Chassis
To Next Page
Loading...
