Alcatel-Lucent OmniSwitch 6250 - Page 337

SNMP Trap Information SNMP Traps Table
OmniSwitch 6250/6450 Switch Management Guide May 2012 page B-29
ifIndex—The interface that was shut down due to the violation.
esmPortViolationValue—The reason the interface was shut down.
EniSecurityBlockPortNone(0) No App blocking this port
EniSecurityBlockPortENI(1) ENI App blocking this port
EniSecurityBlockPortSTP(2) STP App blocking this port
EniSecurityBlockPortLPSS(3) LPS Shutdown App blocking this port
EniSecurityBlockPortQoS(4) QoS App blocking this port
EniSecurityBlockPortUDLD(5 UDLD App blocking this port
EniSecurityBlockPortETHBLK(6) ETHBLK App blocking this port
EniSecurityBlockPortNISUP(7) NISUP App blocking this port
EniSecurityBlockPortLLDP(8) LLDP App blocking this port
EniSecurityBlockPortRFP(9 ) RFP App blocking this port
EniSecurityBlockPortLinkMon(10) LinkMon App blocking this port
EniSecurityBlockPortLFP(11) LFP App blocking this port
EniSecurityBlockPortLPSD(12) LPS Discard App blocking this port
178
Reserved
179
Reserved
180
alaTestOamTxDoneTrap
alaTestOam-
ConfigTestId,
alaTestOam-
Config-
SourceEndpoi
nt,
alaTestOam-
ConfigTestId-
Status
bridge After a configured time interval,
this trap is sent to the NMS from
Generator switch when the test
duration expires.
alaTestOamConfigTestId—A unique name to identify the entries in the table.
alaTestOamConfigSourceEndpoint—The the local or transmitting switch. For bidirectional test, this also
identifies the analyzer switch.
alaTestOamConfigTestIdStatus—The test status (not started, running, stopped, ended).
181
alaTestOamRxReadyTrap
alaTestOam-
ConfigTestId,
alaTestOam-
Config-
SourceEndpoi
nt,
alaTestOam-
ConfigTestId-
Status
bridge This trap is sent to the NMS once
the switch with Analyzer or
Loopback Role is ready to
receive test traffic. Once this trap
is received, the Generator is acti-
vated for generating test traffic.
alaTestOamConfigTestId—A unique name to identify the entries in the table.
alaTestOamConfigSourceEndpoint—The the local or transmitting switch. For bidirectional test, this also
identifies the analyzer switch.
alaTestOamConfigTestIdStatus—The test status (not started, running, stopped, ended).
182
alaTestOamTestAbortTrap
alaTestOam-
ConfigTestId
bridge This trap is sent to the NMS from
the switch, if the test is aborted
during takeover.
alaTestOamConfigTestId—A unique name to identify the entries in the table.
No. Trap Name Objects Family Description