Alcatel-Lucent OmniSwitch AOS Release 6 - Page 112

SNMP Overview Using SNMP
page 3-26 OmniSwitch AOS Release 6 Switch Management Guide July 2010
67 alaVrrp3TrapProtoError alaVrrp3TrapPr
otoErrReason
vrrp The error trap indicates that the
sending agent has encountered
the protocol error.
alaVrrp3TrapProtoErrReason
—This indicates the reason for protocol error trap.
68 alaVrrp3TrapNewMaster alaVrrp3OperM
asterlpAd-
drType
alaVrrp3OperM
asterlpAddr
alaVrrp3TrapN
ewMaster-
Reason
vrrp The newMaster trap indicates
that the sending agent has transi-
tioned to Master state.
alaVrrp3OperMasterlpAddrType—This specifies the type of alaVrrp3OperMasterlpAddr in this row.
alaVrrp3OperMasterlpAddr—The master switch’s real (primary for vrrp over IPv4) IP address. This is the Ip
address listed as the source in the advertisement last received by this virtual switch. For IPv6, a link local
address.
alaVrrp3TrapNewMasterReason—This indicates the reason for NewMaster trap.
69 gmHwMixModeSubnetRuleTable-
OverloadAlert
gmSubnetRule-
Table
gmOverloadRu-
leSlice
vlan A subnet overload trap occurs in
mixed mode whenever a new
entry to the HW subnet rule table
gets dropped due to the overload
of the table.
gmSubnetRuleTable—Overloaded HW subnet rule table.
gmOverloadRuleSlice—Overloaded slot Id.
Note: This trap is not supported.
70 pethPwrSupplyConflict pethSourceSlot chassis This trap is sent when there is a
power supply conflict in a POE
device.
pethSourceSlot—Slot number of generating entity.
71 pethPwrSupplyNotSupported pethSourceSlot chassis This trap is sent when the power
supply is not supported.
pethSourceSlot—Slot number of generating entity.
72 lpsPortUpAfterLearningWindowEx-
piredT
lpsTrapSwitch-
Name
lpsTrapSwitch-
Slice
lpsTrapSwitch-
Port
systemServices-
Date
systemServices-
Time
bridge This trap is sent when an LPS
port joins or is enabled after the
Learning Window is expired, dis-
abling the MAC address learning
on the port.
This trap is also generated at the
time the Learning Window
expires, with a slice and port
value of 0.
lpsTrapSwitchName—The name of the switch.
lpsTrapSwitchSlice—The slot number for the LPS port on which the violation occured
lpsTrapSwitchPort—The port number for the LPS port on which the violation occured
systemServicesDate—The current System Date in the following format: MM/DD/YYYY.
systemServicesTime—The current System Time in the following format: HH:MM:SS.
No. Trap Name Objects Family Description