EasyManua.ls Logo

Alcatel-Lucent OmniSwitch AOS Release 6 - Page 120

Alcatel-Lucent OmniSwitch AOS Release 6
346 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SNMP Overview Using SNMP
page 3-34 OmniSwitch AOS Release 6 Switch Management Guide July 2010
98 alaPimInvalidJoinPrune alaPimGroup-
MappingPim-
Mode
alaPimInvalid-
JoinPruneAd-
dressType
alaPimInvalid-
JoinPruneOri-
gin
alaPimInvalid-
JoinPrune-
Group
alaPimInvalid-
JoinPruneRp
alaPimNeigh-
borUpTime
ipmr This trap is sent when an invalid
PIM Join/Prune message is
received.
The notification is generated
whenever the PIM Invalid Join
Prune Messages Recieved
counter is incremented, subject to
the rate limit specified by the
PIM Invalid Join/Prune Notifica-
tion Period.
alaPimGroupMappingPimMode—The PIM mode used for groups in this group prefix.
alaPimInvalidRegisterAddressType—The address type stored in alaPimInvalidRegisterOrigin, alaPimIn-
valid RegisterGroup and alaPimInvalidRegisterRp. If no unexpected Register messages are received, the onject
is set to “Unknown”.
alaPimInvalidJoinPruneOrigin—The source address of the last unexpected Join/Prune message received
alaPimInvalidJoinPruneGroup—The IP multicast group address carried in the last unexpected Join/Prune
message received
alaPimInvalidJoinPruneRp—The RP address carried in the last unexpected Join/Prune message received
alaPimNeighborUpTime—The time since this PIM neighbor (last) became a neighbor of the local router.
99 alaPimRPMappingChange
alaPimGroup-
MappingPim-
Mode
alaPimGroup-
MappingPre-
cedence
ipmr This trap is sent when a change is
detected to the active RP map-
ping on the device.
The notification is generated
whenever the PIM RP Mapping
Change Count is incremented,
subject to the rate limit specified
by PIM RP Mapping Change
Notification Period
alaPimGroupMappingPimMode—The PIM mode used for groups in this group prefix.
alaPimGroupMappingPrecedence—The value for alaPimGroupMappingPrecedence to be used for this static
RP configuration. This allows fine control over which configuration is overridden by this static configuration
100 alaPimInterfaceElection alaPimInter-
faceAd-
dressType
alaPimInter-
faceAddress
ipmr This trap is sent when a new DR
or DR has been elected on a net-
work.
The notification is generated
whenever the counter PIM Inter-
face Elections Win Count is
incremented, subject to the rate
limit specified by PIM Interface
Election Notification Period.
alaPimInterfaceAddressType—The address type of the PIM interface.
alaPimInterfaceAddress—The primary IP address of this router on this PIM interface.
No. Trap Name Objects Family Description

Table of Contents

Related product manuals