Getting Started Mounting the Switch
OmniSwitch 6350 Hardware Users Guide September 2015 page 2-3
Airflow Considerations
To ensure proper airflow, be sure that your switch is placed in a well-ventilated area and provide minimum
recommended clearance at the front, back and sides of the switch.
Never obstruct chassis air vents.
Chassis Top View
Note. Clearance is not required at the top and bottom of the chassis.
Mounting the Switch
For information on mounting OmniSwitch 6450 switches, refer to Chapter 3, “OmniSwitch 6450 Chassis and
Hardware Components.”
}
}
Rear. 6 inches minimum
at rear of chassis.
Front. 6 inches minimum
at front of chassis.
Sides. 2 inches minimum
at left and right sides.
To Next Page
Loading...
